Sonenalp 4 Guest Guide
  • HOME
  • Essentials
  • Rooms
  • Amenities
  • LOCAL
Picture

Fireplaces

There are two fireplaces: One in the Master Bedroom and one in the Living Room. They should be ready for you. All you should need to do it flip the wall switch to "ON."

The switches are mounted on the wall adjacent to each fireplace.

​
If they don't come on automatically, feel free to call us for help but there are a couple of things you can check:

Picture
Look to the bottom left of the fireplace, just under the logs. Is there a visible pilot light? 

If the pilot light is out, you can re-light it following the Pilot Relight procedure below.

If the pilot light is lit, the controller needs to be reset. Follow the Controller Reset procedure below.


Picture
Both procedures require access to the bottom of the fireplace. 

Simply open up the black slatted panel under the fireplace to take a look at the fireplace controls.

Picture
Ensure that the red gas control handle is turned horizontally, and 'in line' with the gas line as shown in the picture to the left.

Picture
Take a look at the controls.
  • The on/off switch should be set to OFF.
  • The round knob should be in the  "ON" position. 
Picture
Pilot Relight Procedure
1) Turn the black knob to line up the word PILOT with the red dot on the bottom of the controller.
2) Push in and hold the black knob.
3) Push and release the red button until the pilot light ignites
4) Continue to hold in the black knob for 30 seconds after the pilot light begin to burn.
5) Rotate the black knob to line up the word ON with the red dot
6) Make sure the pilot light remains lit. 


Picture
Controller Reset Procedure
1) Cycle the ON/OFF switch
2) Leave the switch in the OFF position
​3) Turn the wall switch to the ON position

Home

Essentials

rooms

AMENITIES

LOCAL

Copyright © 2019, Adventure Refined, A CA Corp
Picture
  • HOME
  • Essentials
  • Rooms
  • Amenities
  • LOCAL